To download a driver card directly into the DigidownPlus, insert the card with the chip down
into the slot in the side of the unit. The download will start automatically and the LED
beside the 'card' button will flash repeatedly about twice a second during the download.
Successful downloading is indicated by the LED blinking briefly about once a second.
Downloading a driver card directly into the DigidownPlus takes in the region of 30 seconds.
In order to download directly, the DigidownPlus must be powered either by 2 x AA batteries,
or by USB connection to a computer. The DigidownPlus should not be connected to the
tachograph during a direct card download.
Using a VU
To download a driver card via the VU you will need to insert the driver card into one slot
of your tachograph and your company card into the other.
Connect your DigidownPlus to the 6 pin connector on the front of the VU - this may
be behind a small cover or in the printer drawer. The DigidownPlus will indicate it
is ready by blinking each of its LEDs in turn. Press the 'card' button.
During the download, the LED by the selected button will flash repeatedly about
twice a second. Successful completion of the download is indicated by the LED
blinking briefly about once every second. The downloading of a driver card will
usually take only a few minutes to complete.
Please do not disconnect the DigidownPlus during a download. Doing so may cause errors
on the SD card.